Error messages via blink codes
LED “ERROR”
Appendix Blink codes
As described in the chapter “Operator Control Panel”, blinking of the red
LED “ERROR” indicates that an error has occured. The respective blink
codes are shown graphically in the following section. The blinking cycle
lasts about 2 sec.
Recoverable errors
The following errors can be recovered by DLE ENQ 1 or DLE ENQ 2 con-
trol command.
Automatic cutting error
Home position detection error
Carrier detection error
Should the errors mentioned above occur, check whether the ribbon is
blocking or whether there is residual paper in the printer housing - if so, re-
move it.
Appendix Blink codes
GB - 49
Comments to this Manuals