Wincor Nixdorf ND77 User's Guide download pdf (Page 11)

Introduction Care of the ND77

Before cleaning make sure that the power is switched off, the power supply

plug is disconnected and that no moisture gets into the printer.

To clean the inner housing use a soft brush or a small vacuum cleaner.

Please make sure that there is no remaining paper in the carrier area.

Carefully clean the cutter area to remove paper dust. Make sure the rib-

bon is free of paper dust. Always keep the area of carrier-home sensors

clean (see picture below).

Clean the deflection prism located on the document plate (see figure be-

low) with a soft cloth.

Carrier-home

sensor

deflection prism

Introduction Care of the ND77

GB - 5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 62 63

No comments

Wincor Nixdorf ND77 User's Guide Page 11